Several maintenance methods of motor rotor winding machine

    The failure of the motor rotor winding machine is nothing more than the electrical, mechanical and transmission aspects. A set of relatively complete solutions has been explored for the troubleshooting of these aspects. The following is a brief introduction for everyone.

     1. Whole machine reset method

     The reset method of the whole machine seems complicated, but the actual principle is very simple, that is, when the fault causes the whole machine error of the motor rotor winding machine, the fault is cleared by resetting the hardware or switching the power supply. This method is mainly aimed at the whole machine error problem caused by transient fault.

   2. Programming test run method

     Before starting, compile a program to determine whether the software system of the motor rotor winding machine can work normally. The specific judgment is whether the program can run successfully. For this part, it is necessary to have a certain technical ability and a person who has a very clear understanding of the motor rotor winding machine to guide the preparation of the program.

     3. Spare parts substitution method

     Said it is a spare parts replacement method, in fact, when the motor rotor winding machine fails, the faulty component is replaced with a spare non-destructive component. This method is faster and simpler, but the cost is greater than the above two methods.